Ibex
Y Blade for TX52, TS62, TM73, TL84, and TM62 Offset Flails (eagle mark)
- SKU:
- PSDMURC404D
- MPN:
- URC404D
- Condition:
- New
- Shipping:
- Calculated at Checkout
Description
This is a replacement Y blade for the models listed below. Please check the mark on the blade. This is the blade with an eagle mark on the front of the blade. If your blades have an anvil mark, you must replace it with these blades, as the anvil mark blade has been discontinued.
IMPORTANT NOTE: You cannot mix and match anvil mark and eagle mark blades, because the two have different weights and your rotor must be balanced. However, the new eagle mark blades are fully compatible with older models.
Please check your mower against this list before purchasing.
Fits the following models:
Ibex TX52 Flail Mower (Del Morino Flipper 132): Full set here (40 blades)
Ibex TS62 Flail Mower (Del Morino Flipper 158): Full set here (48 blades)
Ibex TM62 Hydraulic Offset Flail Mower (Del Morino Centurion Super 158): Full set here (48 blades)
Ibex TM73 Flail Mower (Del Morino Flipper 186): Full set here (56 blades)
Ibex TL84 Flail Mower (Del Morino Flipper 214): Full set here (64 blades)
Rated to cut up to 2" thick material.
Dimensions:
Width - top (mounting hole edge): 1.58"
Width - bottom (cutting edge): 2.23"
Hole diameter: 0.80"
Thickness: 0.32"
Height (measured at an angle, from cutting edge to top of mounting edge): 4.75"